ACDelco GM OE SPRING ASSIST GAS CHARGED SHOCK ABSORBERS

  • ACDelco GM OE Spring Assist Gas Shock Absorbers Primary Image

FEATURES & BENEFITS

  • For utility vehicles that operate under ongoing load conditions
  • GM-recommended replacement part for your GM vehicle’s original factory component
  • Offering the quality, reliability, and durability of GM OE
  • Manufactured to GM OE specification for fit, form, and function

MORE ACDelco PARTS
 

ACDelco GM OE Shocks
ACDelco GM OE Air Lift Shocks
ACDelco Professional Gas-Charged Shocks
ACDelco Shocks, Struts, And Suspension Parts
PRODUCT DETAILS


ACDelco GM Original Equipment Spring Assist Gas Charged Shock Absorbers control the oscillation of the suspension and are the GM-recommended replacements for your vehicle’s original components. A shock absorber is a hydraulic piston and cylinder that is designed to resist the up-and-down movement of the suspension. The shock has a valve or orifice that allows the piston to move up and down the cylinder tube at a controlled rate. The valving located at the bottom of the shock tube is tailored to the vehicle and suspension characteristics. These shocks also include a coil spring to stiffen the shock for maximum vehicle load conditions. These original equipment shock absorbers have been manufactured to fit your specific GM vehicle, providing the same performance, durability, and service life you expect from General Motors.

WARRANTY


Limited Lifetime Warranty: ACDelco offers a Limited Lifetime Warranty on specific service parts. General Motors warrants to the purchaser that it will replace these specific Genuine GM Parts and ACDelco parts for all manufacturer defects in workmanship and manufacturing. Effective on parts purchased April 1, 2018 and later to the original retail purchaser. Contact seller for limited warranty part details, qualifications, and possible labor coverage.

FAQs


Is there a difference between a shock and a strut?
Yes, though shocks and struts perform a similar function, they vary greatly in their design. Struts are an integral part of a vehicle’s suspension system, providing structural support for the vehicle. Shocks work separately from any structural function, simply absorbing and damping the bumps from the road.

 

Do gas charged shocks or struts contain oil?
Yes, all shocks and struts use hydraulic fluid (oil) to control damping. A gas charged shock or strut uses high-pressure nitrogen gas to minimize oil foaming during high-speed damping, and therefore maintains performance.

 

Can I check my vehicle’s shocks or struts for wear?
Yes, it is possible to do a quick check at home for wear on your vehicle’s shocks or struts. You can look for any physical damage to the shock or strut housing or any leaking – this is especially common on rear units that tend to have stones kicked up by the front wheels. You can also perform a bounce test by taking each corner of the vehicle and pushing down hard. The corner should drop, rise and settle again. If the body continues to move up and down, there’s a good chance your shocks need to be replaced. Though these home tests can indicate worn shocks or struts, it is also recommended that you take your vehicle to a qualified service technician and let them do a thorough inspection. Refer your owner’s manual for frequency.

 

Should I have my vehicle aligned after replacing my shocks or struts?
Yes, if you are replacing your vehicle’s struts. However, it is not necessary to get your vehicle aligned when replacing your vehicle’s shocks unless there was a previous issue.

 

Do I need different shocks for front, rear, left, or right applications?
Yes, it is important to choose the correct shock or strut for your vehicle model and year, as well as for the location in the vehicle.

MAINTENANCE TIPS


Your vehicle’s shocks and struts slowly deteriorate over time, though this wear is normally difficult to detect. To maximize your vehicle’s ride comfort, it is recommended to replace your vehicle’s shocks and struts every 50,000 miles. Worn shocks and struts can also cause additional wear to other vehicle components. Affected components include:

• Brakes
• Tie rods
• Ball joints
• Tires

 

To inspect your shocks and struts to gauge wear, check for:

• Leaking oil or wetness along the body of the shock or strut.
• Broken mounts, worn or missing bushings.
• Broken, damaged, or missing mounting hardware.
• Severely dented reservoir tube, bent or scratched piston rod.
• Cupped tire wear.
• Damaged strut body springs, seats, and bushings.
• Defective strut bearing or missing plate.

 

Occasionally, twin-tube designs are misdiagnosed as defective due to the settling of oil during storage, which causes the shock or strut to seem soft or “dead”.

• Priming a shock will return all oil/gas content to its intended position & ensure proper operation of the unit.
• Based on application, not all struts will prime regularly.
• To prime a shock or a strut, compress and release the piston rod a few times until the full resistance of the shock returns.

 

  •  

    YOU MAY ALSO LIKE
        

ACDelco Steering
ACDelco Tie Rods
ACDelco Ball Ends Joints
ACDelco Idler Arms

Search Parts Cataloge
Locate Service Center
Locate Parts Store